detect the signals if it has been paired with the charging
station. Refer to
Loop signal on page 49
.
3.7.4 STOP sensor
There is a magnet and a Hall sensor that detects if the
STOP button is pushed down. If the STOP signal is
indicated, the product and the blade disc stop
immediately and the hatch is released.
3.7.5 Collision sensors
There is no collision sensor in this product. The product
measures the wheel motor current to sense collision.
3.8 To do a test of the installation
Note: Turn off
ECO mode
before you do the tests.
With the
Lawn coverage
test you can do a test of the
selected installation settings.
3.8.1 Test: Lawn coverage
Note: The
Test: Lawn coverage
can only be used once
the product has calibrated the guide wire. In other
words, the product must have left the charging station
on at least one occasion, either in
Auto
mode or in
connection with the start-up sequence.
The
Test: Lawn coverage
function is used to test if the
product can follow the guide wire or the boundary loop
at the selected corridor width out from the charging
station.
The
Test: Lawn coverage
can also be used to measure
the distance from the charging station to a remote area.
The distance, stated in meters, is shown in the product
display when STOP is pressed. How to do the test is
described in the Operator's manual.
3.9 Weather timer
If
Weather timer
is activated, the product automatically
adjust its mowing times based on how fast the grass
grows. This is decided by continuously measuring the
blade disc resistance and comparing that to a mean
value. If the resistance is higher than the mean value,
the product is allowed to work for a longer time, and the
other way around. The mean value is continuously
updated and when the mower has collected sufficient
data, the will start to change the cut time.
Note: The mean value will be reset if the settings are
reset, or if the cutting height is lowered.
The
Weather timer
does not make the product work
more than the timer settings, only less. The product will
always perform at least one mowing cycle per day, only
after that the mowing time is reduced by the
Weather
timer
.
3.10 Safe operation in slopes
The product adjusts its operation automatically based on
factors such as the slope angle and travel direction.
If the slope is too steep, the product moves rearwards
and turns to try to find a less steep slope. If after 2
attempts the product cannot find a less steep slope, it
stops and the display indicates that the stop is caused
by a steep incline.
Slopes that exceed the specified maximum inclination
can normally only be reached in very favourable
conditions. Accessibility on steeper slopes than
specified cannot be guaranteed.
3.11 New loop signal
In rare cases, there may be a reason to change the loop
signal. For example, if two nearby installations have the
same loop signal they can interfere with each other.
1. Select a new loop signal via the menu in the display.
Note: A new loop signal has to be generated when the
product returns to its ordinary charging station, for
example after service if a charging station other than the
customer’s has been used. Refer to
Actions on page
16
.
8 - Product and installation 1582 - 001 - 23.12.2020
To Next Page
Loading...
Need help?
General
