8 Troubleshooting
8.1 Messages
The table below contains fault and information messages which can appear in the product.
There are references to menus in the product, but Autocheck can also be used in many cases.
Note: Refer to the Operator's manual for more information about how to rectify errors.
Messages
Number Message Cause Action
0 No message Indicates that no message is stor-
ed.
1 Outside working area The boundary wire connections to
the charging station are crossed.
Check that the boundary wire is
connected correctly to the charg-
ing station.
The boundary wire is too close to
the edge of the work area.
Check that the boundary wire has
been laid according to the instruc-
tions.
The work area slopes too much at
the boundary wire.
Check that the boundary wire has
been laid according to the instruc-
tions.
The boundary wire is crossed on
its way to and from an island.
Check that the boundary wire has
been laid according to the instruc-
tions. Refer to
To examine where
to put the boundary wire
in the
Operator's manual.
The product finds it hard to distin-
guish the signal because of an in-
stallation close by.
Put the product in the charging
station and generate a new loop
signal.
Disturbances from magnetic ob-
jects (fences, reinforcement steel)
or buried cables close by.
Try moving the boundary wire
and/or creating additional islands
in the work area.
1582 - 001 - 23.12.2020 Troubleshooting- 39
To Next Page
Loading...
