7 Service
7.1 Service schedule
The table below contains a checklist of points and actions to be taken when servicing the product.
Every
year
Every
3rd year
Action Explanation
X
Firmware update
If firmware is available in Autocheck, update the
product with the newest firmware.
Refer to
Firmware on page 16
.
X
Autotest
Diagnostic test of all product functions.
Make a complete Autotest in Autocheck. Refer
to
Auto test on page 16
.
X
Service messages
Do a check of the service messages for recom-
mended upgrades.
Updated service bulletins can be found in Au-
tocheck.
X
Cleaning
Remove the body of the product. Clean the
body of the product, the chassis and the
wheels.
Refer to
To remove and install the body on
page 19
.
X
Charging plates
Examine the cable and connector to the charg-
ing plates on the body of the product. Replace if
damaged.
Refer to
To replace the headlights and the
charging plates on page 21
.
X
Rubber grommets
Examine the rubber grommets on the chassis
to make sure that they are completely sealed.
Replace if damaged.
Refer to
To remove and install the body on
page 19
.
X X
Ventilation filter
Examine the ventilation filter and clean carefully
with a soft brush. The ventilation filter should be
replaced after three years of use.
Refer to
To clean and replace the ventilation fil-
ter on page 23
.
X
Hatch
Clean the area around the display cover hinge.
X
Bearings
Examine the rear wheel bearings. Replace if
damaged.
Refer to
To replace the rear wheels on page
31
.
X
Wheels
Examine the front and rear wheels. Replace if
damaged.
Refer to
To replace the front wheels on page 31
and
To replace the rear wheels on page 31
.
X
Body suspension parts
Examine and clean the body suspension parts.
Refer to
To replace the front body suspension
parts on page 22
and
To replace the rear body
suspension parts on page 22
.
X
Bellows
Do a check of the rubber bellow in the cutting
height adjustment. Refer to
To replace the
wheel motors on page 31
.
36 - Service 1582 - 001 - 23.12.2020
To Next Page
Loading...
