Messages
Number Message Cause Action
80 Cutting system imbalanced Too few or too many blades. Check the blades on the blade
disc.
81 Safety function faulty Status LED malfunctioning. Restart the product. If the prob-
lem remains, replace the keypad,
application circuit board or ca-
bling. Refer to
To replace the key-
pad on page 23
,
To replace the
application circuit board on page
26
.
89 Invalid system configuration Wrong configuration of the circuit
boards after replacing a circuit
board.
Redo the configuration in Autoch-
eck.
Messages
Number Message Cause Action
MESSAGES WITHOUT ERROR CODE
NA Needs manual charg-
ing
The product is set to the
Secondary
area
operating mode.
Put the product in the charging station.
This behavior is normal and no further
action is required.
Next start hh:mm The timer setting prevents the product
from operating.
Change the timer settings.
The products clock is incorrect. Set the time.
8.2 Symptoms
The most commonly occurring symptoms are described below. All symptoms are grouped by the situation where they
occur most often.
1. Mowing
2. Searching
3. Following the guide wire
4. Docking
5. Charging
6. Miscellaneous
Note: Refer to the Operator's manual for more information about how to rectify errors.
46 - Troubleshooting 1582 - 001 - 23.12.2020
To Next Page
Loading...
