8.2.2 Symptoms during searching
Symptom Cause Action
The product runs, but the
blade disc does not rotate
The product is searching for the charging
station. The blade disc does not rotate
when the product is searching for the
charging station.
This behaviour is normal and no action is
required.
The product does not find the
guide wire when it is searching
for the charging station.
The guide loop is broken. Check the guide signal, as well as the
settings for following the guide wire. Re-
fer to
Tools - Info on page 10
.
8.2.3 Symptoms during docking
Symptom
Cause Action
The product detects the F sig-
nal, but cannot dock
Dirt/leaves/grass in the charging station
is preventing the product’s charging strip
from making contact with the charging
station’s charging strip.
Clean the charging station.
Malfunction in the charging station's cir-
cuit board or in the F-wire.
Replace the charging station's circuit
board. Refer to
To replace the circuit
board in the charging station on page 33
.
N signal from the antenna plate is faulty. Check N signals. Refer to
Tools - Info -
Loop on page 10
.
The cables for the charging strips in the
product are not connected or connected
incorrectly.
Check that the cable lugs for the charg-
ing strips are intact and properly connec-
ted. Make sure that the correct cable is
connected to the right charging strip. Plus
and minus must be correctly connected.
Refer to
To replace the headlights and
the charging plates on page 21
.
The cables for the contact strips in the
charging station are not connected or are
connected incorrectly.
Check that the cable lugs for the contact
strips are intact and properly connected.
Make sure that the correct cable is con-
nected to the right charging strip. Plus
and minus must be correctly connected.
Refer to
To replace the contact plates in
the charging station on page 34
.
The product drives straight in-
to the charging station
The product cannot detect the F field and
therefore does not turn in front of the
charging station.
Check the LED on the charging station
and the instructions about how to trouble-
shoot the loop signal. Refer to
Loop sig-
nal on page 49
.
48 - Troubleshooting 1582 - 001 - 23.12.2020
To Next Page
Loading...
