Husqvarna R 53 - Changing the Pedal Link

English – 77
E
Changing the pedal link
Dismantling
1. Remove the rear plate. (See page 72)
2. Remove the pedals (1) and (2).
3. Remove the damper (6) from the pedal link.
4. Remove the elbow joint (3) of the upper link
from the pedal link (5).
5. Remove the retainer ring (4) and take off the
pedal link (5) from the axle.
Mounting
1. Clean the pedal link bearing and grease the
axle.
2. Place the pedal link on the axle, and secure it
with the retainer ring (4).
3. Fit the damper (6).
4. Fit the elbow joint (3) of the upper link.
5. Fit the pedals (1) and (2).
6. Check the settings. (See page 78-79)
7. Fit the rear plate. (See page 79)
POWER TRANSMISSION
12
34 5 6
Eng-4 sidan 55-102 97-04-11, 15.4077