Husqvarna RB150 - Gear-Toothed Belt and Steering Issues

English – 11
E
Gear-toothed belt in the
cutting unit becomes
worn too quickly.
Does the gear-toothed
belt need adjusting?
Are the gearwheels
defective?
Are the cutting blade
axles defective?
Are the blade axle
bearings defective?
Gear-toothed belt on the
cutting unit is slipping.
Is the gear-toothed belt
poorly adjusted?
Is the gear-toothed belt
worn?
Are gearwheels in the
cutting unit worn?
TROUBLE SHOOTING
Replace the gear-toothed
belt.
Yes
Yes
No
No
No
Yes
Yes
Replace the relevant
gearwheels.
Adjust the gear-toothed
belt.
Yes
Yes
No
No
Dismantle the faulty axle
bearing(s) and replace
the faulty parts.
Yes
Replace the relevant
gearwheel.
Adjust the gear-toothed
belt.
Replace the defective
blade axle(s).
Eng-3 sidan 1-54 97-04-11, 15.3711