8 PREPARING FOR USE
38
600868-01
– Clean the chain.
– Mount the steel sprocket.
– Grease the chain.
Universal oil spray ( p. 173)
– Clean the radiator fins.
–
Straighten the bent radiator fins carefully.
Condition
Regular use in sand
– Change the piston every 10 operating hours.
8.6 Preparing the vehicle for rides on wet sand
V00899-01
– Check the radiator cap.
Value on the radiator cap 1.8 bar (26 psi)
» If the indicated value does not correspond to the setpoint
value:
Warning
Danger of scalding During motorcycle
operation, the coolant gets very hot and is
under pressure.
– Do not open the radiator, the radiator
hoses or other cooling system compo-
nents if the engine or the cooling system
are at operating temperature.
– Allow the cooling system and the engine
to cool down before you open the radiator,
the radiator hoses or other components of
the cooling system.
– In the event of scalding, rinse the area
affected immediately with lukewarm water.
– Change the radiator cap.
M01106-01
– Mount the air filter rain cover.
Air filter rain cover (79006921000)
Info
Observe the fitting instructions for Husqvarna Motor-
cycles technical accessories.
To Next Page
Loading...
Need help?
General
