Ultra Low Front
Rear Load Excel
P/N 0501930_A 5-1
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
CARE AND CLEANING
Long life and satisfactory performance of any
equipment is dependent upon the care it receives.
To ensure long life, proper sanitation and mini-
mum maintenance costs, these merchandisers
should be thoroughly cleaned, all debris removed
and the interiors washed down, weekly.
Fan Plenum
To facilitate cleaning, the fan plenum is hinged.
After cleaning be sure the plenum is properly
lowered into position
OR PRODUCT LOSS WILL
RESULT
due to improper refrigeration.
Fascia Panels
The fascia panels lift
out, left to right, and
should be cleaned with
a mild detergent and
warm water.
D
O NOT USE AMMO-
NIA-BASED PRODUCTS
TO CLEAN OPTIONAL
ACRYLIC PANELS
.
N
EVER USE ABRASIVE
CLEANSERS OR
SCOURING PADS
.
Exterior Surfaces
The exterior surfaces must be cleaned with a mild
detergent and warm water to protect and maintain
their attractive finish. N
EVER USE ABRASIVE
CLEANSERS OR SCOURING PADS
.
Interior Surfaces
The interior surfaces may be cleaned with most
domestic detergents, ammonia based cleaners and
sanitizing solutions with no harm to the surface.
Always read and follow the manufacturer's
instructions when using any cleaning product.
Do NOT Use:
•Abrasive cleansers and scouring pads, as these
will mar the finish.
• Coarse paper towels on coated glass.
•Ammonia-based cleaners on acrylic parts.
•A hose on lighted shelves or submerge the
shelves in water.
•Solvent, oil or acidic based cleaners on any
interior surfaces.
•A hose on rail lights, canopy lights or any other
electrical connection.
MAINTENANCE
Do not use HOT water on COLD glass surfaces.
This can cause the glass to shatter and could
result in personal injury. Allow glass fronts,
ends and service doors to warm before applying
hot water.
To Next Page
Loading...
