Hussmann D5X-ULEP - Installing End Assemblies

P/N 0501930_A 1-11
Medium Temperature Excel
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
8. Remove protective film from bumper once
installation is complete.
INSTALLING END ASSEMBLIES
View End assemblies must be factory-installed.
Solid End assemblies are normally factory
installed. The following information is provided
for retrofit or field installation.
1. Prepare Case
a. Install Nut Retainers into right end frame
at locations shown.
b. Optional Front Rail Light Only
Check that end cap is in place before gaskets
are applied. See Page 1-15 for details.
C
O
O
L
E
R
W
A
L
L
Insert
Nut
Retainers
Remove Alignment Pins
If Installed
Ultra Low Front
Rear Load
IMPORTANT
Do not remove shipping braces from
BI-FOLD DOORS
until the lineup is complete including
joining and end installation.
Bi-fold door set-up and
operating instructions
begin on Page 1-17