1-2 I
NSTALLATION
P/N 0501930_A WWW
.HUSSMANN.COM
SERIAL PLATE LOCATION
Direct a flashlight through the return air grille
behind the front rail to locate the serial plate on
the left end of the Rear Load model.
EXTERIOR LOADING
Do NOT walk on top of merchandisers or
damage to the merchandisers and serious
personal injury could occur. T
HEY ARE NOT
STRUCTURALLY DESIGNED TO SUPPORT EXCESSIVE
EXTERNAL LOADING
such as the weight of a
person. Do not place heavy objects on the case.
MERCHANDISERS SHIPPED
WITH END INSTALLED
If the case was shipped with the end installed,
two long bolts were used to hold the shipping
brace to the end. If the shipping bolts are
reinserted after removing the brace, they will
extend into the product area. T
HEREFORE, BE
SURE TO REPLACE THESE BOLTS WITH THE SHORTER
BOLTS PROVIDED
. NSF requires any bolt or screw
in the product area be capped or cut off if it has
more than three exposed threads.
NOTE:
Be careful not to damage the factory installed
end while moving the case. Make sure that
tools are positioned past the end and beneath
the merchandiser’s support bar.
SHIPPING BRACES
Move the merchandiser as close as possible to its
permanent location, then remove all packaging.
Check for damage before discarding packaging.
Remove all separately packed accessories such as
kits and shelves.
Do not remove end braces until joining begins.
Recycle braces and hardware.
Do NOT remove shipping braces until
the merchandisers are positioned
for installation.
To Next Page
Loading...
