JOINING INSTRUCTIONS
Sectional construction means that two or more
cases may be joined in line yielding one long
continuous display requiring one pair of ends.
ALL JOINTS MUST BE AIR-TIGHT TO PREVENT
FORMATION OF ICE OR CONDENSATION
.
Prep Case
1. Check to be sure that merchandisers are
level. Locate the Joining Kit and check contents.
2. Remove shelves (if installed), display pans,
and front air grille from the right end.
3. Remove any factory-installed nut retainers
from top frame, upright and bottom shoe of both
ends to be joined.
P/N 0501930_A 1-5
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
Ultra Low Front
Rear Load Excel
To Next Page
Loading...
