4
Installation
Location
The refrigerated merchandisers have been designed for
use only in air conditioned stores where temperature and
humidity are maintained at or below 75°F and 55% relative
humidity. DO NOT allow air conditioning, electric fans, ovens,
open doors or windows (etc.) to create air currents around
the merchandiser, as this will impair its correct operation.
Product temperature should always be maintained at a
constant and proper temperature. This means that from the
time the product is received, through storage, preparation
and display, the temperature of the product must be
controlled to maximize life of the product.
Uncrating the Stand (If Provided; Crating is Optional)
Place the ! xture as close to its permanent position as
possible. Remove the top of the crate. Detach the walls
from each other and remove from the skid. Unbolt the case
from the skid. The ! xture can now be lifted off the crate
skid. Lift only at base of stand!
When crating is not provided, lift at one end panel using
forklift and place a dolly under that end panel such that
end panel rests in the middle of the dolly. Repeat the
same procedure at the other end panel. Once the ! xture
is on dollies, move it carefully out of the truck. This is a
recommendation only. Unloading the ! xture following safe
procedures is the responsibility of the company unloading
and installing these ! xtures.
Exterior Loading
These models have not been structurally designed to
support excessive external loading. Do not walk on their
tops; This could cause serious personal injury and damage
to the ! xture.
Setting and Joining
The sectional construction of these models enable them to
be joined in line to give the effect of one continuous display.
A joint trim kit is supplied with each joint.
To Next Page
Loading...
