2.13
PLC CONTROL SYSTEM E200
NOTE: This instruction manual is applicable to the M-16A and M-20A equipped with a MITSUBISHI PLC manufactured
after and including the following serial numbers:
Machine Model Serial #
M-16A S0801197
M-20A T0801245 + T0801250, T0801252
E200 operator interface.
OPERATION OVERVIEW
The PLC is a programmable logic controller, which allows the operator to run the
machine in both manual and automatic modes.
In manual mode, all functions can be operated by using a combination of selec-
tor switches on the control console and the PLC function buttons. Also the op-
erator has the ability to execute a single cut utilizing a pre programmed “Single
Part Cycle”.
In automatic mode, the PLC has the capacity to program and store 99 jobs. Des-
ignated job numbers can be programmed for quantity required (maximum of 999
pieces) and lengths from 0” to 220” (5588mm).
Jobs can be run individually or in a QUEUE which allows a maximum of 5 jobs
to run consecutively and the queue can be repeated automatically as well.
All machine operators should be familiar with the entire operation instructions prior to operating the machine.
NOTE: If an emergency situation arises during any operation, use the large red mushroom “STOP” button located on the
control panel to shut down the machine. To operate the machine, the “STOP” button must be pulled out.
PLC FUNCTION
KEYS
CURSOR KEYS
DISPLAY WINDOW
ENTER KEY
NUMERIC KEY PAD
BLADE SPEED
(SFM) IN SURFACE
FEET (METERS)
PER MINUTE and
SHUTTLE VISE (LTH)
POSITION
To Next Page
