EDS 3000 IO-Link 7
Status: 2022-07-14 HYDAC ELECTRONIC GMBH Part no.: 669897
4.5 Organisational measures
The operating instructions must always be kept accessible at the place of use of the
measuring system.
In addition to the operating instructions, generally applicable legal and other binding
accident prevention and environmental protection regulations must be paid attention
to and must be mediated.
The respective applicable national, local and system-specific provisions and
requirements must be paid attention to and mediated.
It is mandatory for the operator to inform personnel on special operating features and
requirements.
The personnel instructed to work with the measuring system must have read and
understood the operating instructions, especially section 4 Safety, prior to
commencing work.
The nameplates and any prohibition or instruction symbols applied on the measuring
system must always be maintained in a legible state.
Repairs may only be undertaken by the manufacturer or a facility or person
authorised by the manufacturer.
5 Transportation, Packaging, Storage
5.1 Transport
The EDS 3000 sensor is supplied in a rugged cardboard box.
When receiving and unpacking, make sure the item has been delivered in full and
look out for any possible transport damage. If present, immediately show it to the
shipper.
5.2 Packaging
Do not remove the packing until you are ready to install the unit.
Keep the packing of the device for eventual reuse in case of transport (changing
application areas) or re-storage, it provides the best protection for the device.
5.3 Storage
Information on the permitted environmental conditions at the storage place can be
found in chapter 22Technical Data.
6 Disposal
If the measuring system has to be disposed after expiry of its life cycle, the
corresponding national regulations are applicable.
To Next Page
