Hydac ContaminationSensor CS1220 VIMS - Decommissioning, Disposal, and Spare Parts; Taking the CS1000 Out of Operation; Disposing of CS1000; Spare Parts and Accessories

ContaminationSensor CS1000 Taking the CS1000 out of operation
HYDAC Filter Systems GmbH
en
Page 28 / 36
CS1000 CAT-VIMS3478916 en 2009-04-15.doc 2009-04-15
Taking the CS1000 out of operation
Decommission according to the following steps:
1. Pull electric plug from CS.
2. Depressurize the hydraulic system.
3. Remove the connected hoses/piping from the CS.
4. The CS can now be removed.
Disposing of CS1000
The packing material is to be disposed of as specified by law or national regulations
or be reused.
When decommissioning and/or disposing of the CS, observe all local guidelines and
regulations pertaining to occupational safety and environmental protection. This
applies in particular to the oil in the unit, components covered with oil and electronic
components.
After disassembling the unit and separating the various materials, they can be
reused or disposed of properly in accordance with local regulations.
Spare parts and accessories
Description Pc. Part no.
O-ring for flange connection (4.8x1.78 - 80 Shore FPM) 1 6003048
Socket plug with 2 m cable,
screened, 8-pole, M12x1
ZBE 42-02
1 3281220
Socket plug with 5 m cable,
screened, 8-pole, M12x1
ZBE 42-05
1 3281239
Extension cable 5 m,
Socket plug 8-pole, M12x1 /
Socket plug (male) 8-pole, M12x1
ZBE 43-05
1 3281240
Socket plug with screw clamp,
8-pole, M12x1
ZBE 44
1 3281243