78
Bar Support Unit – BSU
A bar support unit is designed to support material whilst in manufacture. It will
only ever be required if the length of the component / finished part is longer
than the sub spindle head stock.
The lid will be linked to the main x-tract cover, and if possible bolted together
so they lift open as a single unit, meaning that it will simulate the machine door
being opened and stop the machine cell.
The bar support unit should only be installed by a Hydrafeed engineer to align
An interlock switch is utilized as detailed below. A breakdown of parts is also
over page.
This switch comes in two parts, (switch and actuator) and they are separately
mounted, the switch is fixed to the front apron of the Barfeed and the actuator is fixed
to the guard hood.
When the hood is closed the actuator locates in the switch and this will allow
electrical operations in the Barfeed to be carried out.
When the hood is open the actuator is removed from the switch and electrical
operations to the Barfeed are disabled.
**YOU ARE IN BREACH OF THE SAFETY LEGISLATIONS IF ANY SAFETY
DEVICE IS NOT SECURED OR IS MANUALLY OVER RIDDEN WHILST
ELECTICAL AND MECHANICAL OPERATIONS ARE BEING CARRIED OUT**
If there becomes an inherent problem with this component then contact us quoting
the part n
o
.
To Next Page
Loading...
