Hypertherm HyPrecision 50S - Removing the High-Pressure End Cap

HyPrecision 50S/60S/75S Operator Manual 808690 101
5 – Preventive maintenance
Preventive maintenance
Remove the high-pressure end cap
Required parts, tools, and materials
Clean, lint-free towels
Isopropyl alcohol
Square drive socket, 1-1/2 inch × 3/4 inch (included in the 12084 HyPrecision standard tool kit)
1. Remove the stud nuts.
2. Pull the high-pressure end cap off.
3. Clean each part with a lint-free towel and isopropyl alcohol. Examine all parts for deterioration, corrosion, or
damage.
Do not use soap, detergent, or solvents.
1
2
3
1 Studs 2 Stud nuts
3 High-pressure end cap