EasyManuals Logo

Hypertherm HyPrecision 50S User Manual

Hypertherm HyPrecision 50S
202 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #26 background imageLoading...
Page #26 background image
26 HyPrecision 50S/60S/75S Operator Manual 808690
1 Terminology
Terminology
cSt
A centistoke (cSt) is a measurement of kinematic viscosity. Water has a viscosity of 1 centistoke
or 1 mm
2
/second.
cut-pressure mode
High-pressure water from the intensifier that is at cutting pressure. Refer to piece-pressure mode.
CUTTING WATER IN (low-pressure water)
Low-pressure water from a water softener, a reverse osmosis system, a well, or a public utility, that is
between the utility panel and the intensifier (refer to
prefilter water and postfilter water)
CUTTING WATER OUT (high-pressure water)
Water that has been pressurized by the intensifier for piercing or cutting
dB(A)
A-weighted decibels (dB(A)) is an expression of the relative loudness of sounds in air as perceived by the
human ear
dynamic seal
The high-pressure seal in the high-pressure cylinder that is nearest to the hydraulic center section. This seal
is in direct contact with the plunger (refer to
static seal).
energy-isolating device
A mechanical device that physically prevents the transmission or release of energy, including but not limited
to the following: a manually operated electrical circuit breaker, a disconnect switch, a manually operated
switch by which the conductors of a circuit can be disconnected from all ungrounded supply conductors, a
line valve, and any similar device used to block or isolate energy. Push buttons (like the
EMERGENCY STOP
button), selector switches, and other control circuit-type devices are not energy-isolating devices.
energy source
Any source of electrical, mechanical, hydraulic, pneumatic, chemical, thermal, or other energy
fitting
A coupling, valve, or gauge that stops, regulates, or directs the flow of water in a pipe
hard water
Water with dissolved minerals in it, typically calcium and magnesium
high-pressure water (CUTTING WATER OUT)
Water that has been pressurized by the intensifier for piercing or cutting
hose
A flexible hollow cylinder. Dimensions are based on the inside diameter (ID).
inrush current
The maximum instantaneous current that a motor draws when it is first turned on, also called input surge
current or switch-on surge
ISO
The International Organization for Standardization (ISO), an independent membership organization that
develops voluntary standards

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Hypertherm HyPrecision 50S and is the answer not in the manual?

Hypertherm HyPrecision 50S Specifications

General IconGeneral
BrandHypertherm
ModelHyPrecision 50S
CategoryWater Pump
LanguageEnglish

Related product manuals