28 HyPrecision 50S/60S/75S Operator Manual 808690
1 – Terminology
Terminology
SAE
SAE International is a professional association of engineers and technical experts that coordinates the
development of technical standards based on best practices in the aerospace, commercial vehicle, and
automotive engineering. SAE Code 61 fittings are designed for 207-bar or 20,684-kPa (3000-psi)
applications. SAE Code 62 fittings are designed for 414-bar or 41,369-kPa (6,000-psi) applications.
static seal
The high-pressure seal at the output end of the high-pressure cylinder. This seal does not touch the plunger
(refer to
dynamic seal).
supply water
Water going to the pump from a water softener, a reverse osmosis system, a well, or a public utility that is
typically delivered to a location through a system of pumps and pipes
system integrator
An integrator of waterjet cutting systems that are sold directly to end users
tubing
A rigid tube that carries high-pressure fluid
valve
A device used to control the rate of flow in a pipe or a tube
WASTEWATER OUT
Water from the bleed-down valve or the low-pressure system that goes to a drain
weep hole
A small hole that is drilled into high-pressure fittings to let leaking water escape
To Next Page
Loading...
Need help?
General
