48 HyPrecision 50S/60S/75S Operator Manual 808690
4 – Operation
Operation
4. Monitor for leaks. Identify the source of a leak and correct the problem. Refer to Leaks on page 163.
Turn on the pump remotely
1. Make sure that the key switch is set to LOCAL.
2. Push the CONTROLS ON button.
3. Turn the key switch to REMOTE.
4. Refer to the OEM’s instructions for turning the pump on.
WARNING
Do not attempt to repair a leak with pressure in the system.
WARNING
Use a piece of cardboard or other solid material to check for leaks when the pump is on. Do not
use hands, cloth, paper, or towels.
WARNING
Do not leave waterjet cutting equipment turned on and unattended.
To Next Page
Loading...
Need help?
General
