HyPrecision 50S/60S/75S Operator Manual 808690 71
5 – Preventive maintenance
Preventive maintenance
Training
The employer must provide training for maintenance activities and retraining for all workers whenever there is a
change in job assignments, machinery or processes that present a new hazard, or energy-control procedures, or
when a periodic inspection reveals, or an employer has reason to believe, that shortcomings exist in a worker’s
knowledge or use of the energy-control procedure.
Tips
Keep the work area clean and free of fluid spills. Use catch basins under areas where water or hydraulic fluid
can spill during maintenance or repair procedures.
Keep accurate maintenance records.
Keep parts available so that they are ready when required.
Follow local protocols for recycling or disposal of parts and materials. Refer to Recycling and end of product
life
on page 146.
Some materials produce airborne contaminants or suspended particles when cut. Wear approved
respiratory protection.
Do not operate the pump without the shaft access cover and all other safety devices in position. Do
not remove guards while the pump is running.
Follow all safety requirements and applicable safety laws and regulations.
Coordinate preventive maintenance and repair activities with operations and safety staff.
Examine and clean the equipment regularly. Make repairs immediately.
Use proper tools for maintenance procedures. Some tools are designed to make the procedure
easier and to prevent damage to the equipment.
People who maintain and repair this equipment must know how to use standard hand tools.
Before reassembling high-pressure or hydraulic parts, clean the parts to remove dirt and other
contaminants.
Put the parts on a clean, dry, oil-free surface.
To Next Page
Loading...
Need help?
General
