Powermax105 Operator Manual 2-13
Minimum inlet pressure (while gas is flowing)
This table shows the minimum required inlet pressure when the recommended inlet pressure is not available.
Torch lead length
7.6 m (25 ft) 15.2 m (50 ft) 22.9 m (75 ft)
Cutting 5.2 bar (75 psi) 5.5 bar (80 psi) 5.9 bar (85 psi)
Gouging 4.1 bar (60 psi) 4.5 bar (65 psi) 4.8 bar (70 psi)
Gas flow rates
Cutting 220 slpm (460 scfh, 7.7 scfm) at a minimum 5.9 bar (85 psi)
Gouging 230 slpm (480 scfh, 8.0 scfm) at a minimum 4.8 bar (70 psi)
To Next Page
Loading...
