Hypertherm Powermax105 - Installing Hand Torch Consumables

Hand TorcH SeTup
4-6 Powermax105 Operator Manual
Install the hand torch consumables
WARNING:
INSTANTON TORCHES
PLASMA ARC CAN CAUSE INJURY AND BURNS
The plasma arc comes on im me di ate ly when the torch trigger is activated.
Make sure the power is OFF before changing consumables.
To operate the hand torch, a complete set of consumable parts must be installed: shield, retaining cap, nozzle,
electrode, and swirl ring. Torches ship without consumables installed. Pull off the vinyl cap before installing your
consumables.
With the power switch in the OFF (O) position, install the torch consumables asshown below.
Retaining cap
Electrode
Swirl ring
Shield
Nozzle