Hypertherm powermax1650 User Manual

10. The power ON (green) and fault
(red) lamps are flashing.
10.1 Self-diagnostic failure.
The system needs repair.
11. The power ON (green) and fault
(red) lamps are illuminated after
the power is turned on.
11.1 The start signal is ON when the ON/OFF
switch is activated.
Turn the start signal OFF. Turn the power OFF
and then ON again.
12. The power ON (green) and
fault (red) lamps are
illuminated for 10 seconds
after the trigger is activated.
12.1 The consumables are stuck or jammed.
Turn the power OFF and check the
consumables.
Basic troubleshooting (continued)
Problem Cause / Solution
5-8 powermax1650 Operator Manual
2
MAINTENANCE AND PARTS

Hypertherm powermax1650 Specifications

General

Brand	Hypertherm
Model	powermax1650
Category	Welding System
Language	English