Hypertherm powermax1650 - Mode Switch and Power On

OPERATION
2
powermax1650 Operator Manual 4-7
Set the mode switch
Use to cut expanded metal.
Automatically reinitiates pilot.
Use to cut plate/sheet metal.
Optimum consumable life.
Use to gouge, or for non-transfered-arc operation.
Turn ON the power
Position the power switch to ON ( I ) as shown.
Note: The cooling fan is automatic and will only operate
when needed.
Check that the power ON lamp is illuminated.
Check the indicator lights
AC
V
Check that the remaining indicator lamps are NOT illuminated. See Section 5, Maintenance and
parts, for details.
Check that the gas pressure LED illuminates green.