OPERATION
2
4-10 powermax1650 Operator Manual
Attach the work clamp securely to the workpiece.
Remove rust, paint or other coatings to ensure
good electrical contact.
Attach the work clamp as close as pos si ble to the
area being cut, to reduce exposure to
electromagnetic fields (EMF).
Do not attach the work clamp to the portion that
will fall away.
Start a cut from the edge of the workpiece
Hold the torch vertical at the edge of the
workpiece.
Start cutting from the edge of the workpiece.
Pause at the edge until the arc has completely cut
through the workpiece.
Then, proceed with the cut.
Attach the work clamp
WARNING
SPARKS AND HOT METAL CAN INJURE EYES AND
BURN SKIN
When firing the torch at an angle, sparks and hot metal will spray out
from the nozzle. Point the torch away from yourself and others.
To Next Page
Loading...
