22
Using the control panel & remote
control
SLEEP MODE
With the mains switch turned on at the rear of the machine, the
G10 Mini will be in standby mode. This will be indicated by the
fact that there is a blinking red light visible from the time window,
and that there will be no digits showing in either the time window
or the frequency window.
READY MODE
From sleep mode, pressing the power button will turn the G10
Mini to ready mode. From ready mode the frequency can be
pre-selected, by using the frequency UP/DOWN buttons, so that
the G10 Mini will start at tthe frequency preferred frequency for a
particular exercise.
Once you have chosen a frequency, select either 30, 60, or 90
seconds for the exercise duration.
Once a time selection has been made, the G10 Mini will provide a
5 second countdown with an audible beep on the last 3 seconds.
After the 5 second countdown, the platform will start producing
vibration and the time window will countdown the time chosen for
the exercise duration.
The frequency can be adjusted whilst the platform is producing
vibration via the use of the frequency UP/DOWN buttons. To stop
the vibration during an exercise, press the power button.
To turn the G10 Mini back to sleep mode, press and hold the pow-
er button for 3 seconds.
To Next Page
Loading...