14
Machine Assembly
Step 1
Ensure vibration insulator (D) is located on the lower end of post
(F).
Connect the base unit wire connector (L) to the lower post wire
connector (K).
Install post (A) onto the base unit (B), then slide the vibration in-
sulator (D) down to insulate the post (A) from the base cover (G).
Fasten the post (F) to base unit (B) using the wrench (J), with bolts
(E).
Step 2
Connect the control panel wire connector (N) to the upper post
wire connector (M).
Align the control panel (C) to the post (A), and fasten it using the
wrench (J), with bolts (E)
Parts List
A. Post [1]
B. Base Unit [1]
C. Control Panel [1]
D.Vibration Insulator [1]
E. Bolts M10x20 [8]
H. Vibration Straps [2]
To Next Page
Loading...