EasyManua.ls Logo

Hyster E40XMS - Page 8

Hyster E40XMS
26 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Description 2200 SRM 514
Table 1. Instrument Cluster, Internal Combustion (Continued)
Item
No.
Item Function
9
Coolant Level/Hot
Warning Light
Used ONLY On
Later Model
H/S2.00-3.20XM
(H/S40-65XM)
Trucks
CAUTION
Do not continue to operate the lift truck if
the light is ON during operation.
The red light is ON when the key is in the
START position and must go OFF when the
engine is running. If the light flashes when the
engine is running, the level of the coolant in
the radiator is too low. The sending unit for the
warning light is in the top of the radiator. If the
warning light does not work, check the wiring or
replace the sending unit or light.
The light will also come on when the coolant
temperature reaches 121
C(250F).
To check the wiring, see the service manual
section for Diagrams.
10
Warning Light,
Fasten Seat Belt
WARNING
Always fasten the seat belt when operating
the lift truck.
The red light is ON for 10 seconds any time the
key is put in the ON position. This warning
light is activated by a switch in the seat. If the
light does not work correctly, check the switch
or wiring or replace the circuit board. To check
the wiring, see the service manual section for
Diagrams.
11
Warning Light,
Water in Fuel Filter
(Diesel Only)
The red light is ON when the key is in the
START position and must go OFF when the
engine is running. If the light is ON when the
engine is running, there is water in the fuel filter.
The sending unit for the warning light is in the
fuel filter. If the warning light does not work,
check the wiring or replace the sending unit or
light. To check the wiring, see the service manual
section for Diagrams.
12
Indicator Light,
Cold Start (Diesel
Only)
The red light is ON when the key is in the ON
position and the glow plugs are activated. The
length of time that the light is ON (glow plugs
activated) is determined by the temperature of
the engine. When the light goes out, the engine
can be started. When the starter is cranking, the
light will come ON again until the starter is off
and the engine is running.
4

Related product manuals