35
If the Alarm w/Call To Follow feature is enabled by your dealer, you can speak into the microphone without
pressing and holding the PTT key. If the preset voice cycles expire, you can press and hold the PTT key to
initiate the emergency call again.
8.11.2 Receiving an Emergency Call
You can answer an emergency call without any operation.
8.11.3 Ending an Emergency Call
The calling party can end an emergency call in either of the following ways:
Press the preprogrammed Emergency Off key.
Turn off the radio.
The called party can exit an emergency call by switching the channel or turning off the radio.
8.12 Emergency Erase Data
The Emergency Erase Data feature allows the radio to erase encrypted data in case of emergency, so as to prevent
unauthorized access. When erasing the data, the radio stops voice and data services and returns to the home screen.
If this feature is enabled by your dealer, the encrypted data can be erased in the following cases:
Press SK1 and then the PTT key (within 1.5s) for two times, and then press SK1 again.
When the radio is killed, the data on the radio will be erased automatically.
8.13 Radio Disable/Enable
You can send the Radio Disable command to a private contact to disable its radio. The disabled radio is incapable
of any function except the remote monitor. The disabled radio must be reprogrammed by the dealer or enabled by
the Radio Enable command for reuse.
You can send the Radio Enable command to a private contact to restore its radio to normal use.
To Next Page
Loading...
Need help?
General
