Requirements for Pollution Control Identification for Electronic Information
Products
The names of each poisonous or harmful substance or element present in this product, along with the symbol
corresponding to the content of each of such substances and elements, are listed in the following table:
Component
name
Poisonous or harmful substances or elements
Lead (Pb) Mercury (Hg) Cadmium
(Cd)
Hexavalent
chrome
(Cr6+)
Polybro-
minated
biphenyls
(PBB)
Polybromi-
nated diphe-
nyl ethers
(PBDE)
Casing
Circuit board
assembly
Power cord/
adapter
External
signal cable
LCD panel
* : The circuit board components include a printed circuit board and its constituent parts and components,
such as resistors, capacitors, integrated circuits, connectors, etc.
: This symbol indicates that the content of the corresponding poisonous or harmful substance in all of
the homogeneous materials constituting the corresponding component is below the limit specified in the
Standard for the Content Limits for Poisonous or Harmful Substances in Electronic Information Products.
: It indicates that in at least one homogeneous material of that component the content of this toxic
substance exceeds the limit requirement specified in the Limit Requirements for Toxic or Harmful
Substances in Electronic Information Products (SJ/T11363-2006).
Note on the Environmentally Friendly Use Period
When this electronic information product is used under the operating conditions specified in the operating in-
structions, the period in which the toxic or harmful substances or elements it contains do not leak out or cause
pollution to the environment or serious damage to individuals or properties, is 10 years.
1. Where the MAINS plug or an appiance coupler is used as the disconnect device, the disconnect device shall
remain readily operable.
2. The I class structural device should be connected to the power output socket with protected GND
interlinkage.
Safety precautions
To Next Page
