To connect, the following setup steps need to be completed:
1. Loading the app from the app store (Google Play and Apple store).
2. Using the app to connect to IBC's AHU WiFi .
3. Using the app to view the AHU's information.
3.4.1 Loading IBCconnect
Loading the app will depend on whether you are using an Android or Apple iPhone device.
3.4.1.1 Loading IBCconnect from the Android Google Play Store
1. In the Google Play Store search box, enter IBC Technologies (case sensitive).
2.
Select the icon, and tap Install. To verify that the app has loaded, see the icon
in the list with existing apps.
For next steps, see Using the app to connect to IBC's AHU WiFi on page 44.
3.4.1.2 Loading IBCconnect from the iOS Apple Store
1. In the iOs Apple Store search box, enter IBC Technologies (case sensitive).
2.
Select the icon, and tap Install.
Once IBCconnect is installed on your device, you need to change some of the settings. This may
vary slightly depending on the device and the version of iOS your device is using.
3. In the main iPhone Settings, select Cellular.
4. Locate IBCconnect under Cellular Data, and set to Off.
Optionally, in the main iPhone settings, select IBCconnect app, and then go to Siri & Search and set
Search & Siri Suggestions to Off. See the next section for WiFi connection.
3.4.2 Using the app to connect to IBC's AHU WiFi
Once you've loaded the IBCconnect app onto your mobile or tablet, you will need to establish a
connection between the IBCconnect app and the IBC air handler. IBC's AHU has a WiFi access point built
into it. Your device needs to be connected to IBC's AHU WiFi point before the app can be used to control
or monitor IBC's air handler. This is done through the app's WiFi network settings.
To Next Page
Loading...
Need help?
General
