IBERITAL
Page 58 INSTALLATION AND OPERATION MANUAL
ENGLISH
ATTENTION: If the water quantity is left at zero ‘0’ litres, the option will be DISABLED.
Lastly, press the MENU button to exit the TECHNICAL MENU.
Off hh.mm
2.10.- DISPLAY ALARM SIGNALS
A. MAXIMUM FILLING TIME FOR BOILER WATER
When a time set by the manufacturer is exceeded, the display will show:
Time-out alarm
Boiler fi llingUp
At the same time, the button LEDs begin to fl ash.
To cancel the alarm, the main switch must be set to 0 and then to 1.
B. MAXIMUM BOILER TEMPERATURE
The display will show the boiler temperature alarm when it exceeds 140ºC for more than 5 seconds.
Alarm
Boiler temp.
The alarm will disappear when the boiler temperature returns to its normal values.
C. INTERRUPTED TEMPERATURE SENSOR
- When the sensor detects a temperature of 0ºC for 5 seconds, the LEDs on the button pads will
fl ash and the display will show:
T.ProbeUnconnect
The alarm will disappear when the boiler temperature is once again at an acceptable value.
- In the case of the control unit being replaced, a machine with a display and pressure switch will
display:
T.ProbeUnconnect
This situation is due to an incorrect selection on the heating menu (reprogram the control unit). (SEE PROGRAMMING
IN SECTION 2.9.5, HEATING MENU OPTION.)
In order to eliminate this alarm:
Press the MENU button until the following appears (even if the message ‘Probe Unconnect’) appears, do not stop
pressing MENU):
Language
xxxxxx
Press the MENU button repeatedly to go through various options until you see the following on the display:
Mixed tea
with pump / without pump
To Next Page
Loading...
Need help?
General
