If
you key an incorrect accent, press the RESET key to cancel the Dead Key
operation and then replace the accent (at the cursor location) with the correct
accent.
If
your
second keystroke
is
not
a valid letter or a space, a Do Not
Enter-
"Accent Plus What"
()(
*'
+?,)(
*'
+?
,)(
*"'+?,)(
*"+?,
or
)(
* J
+?
) message appears in the Operator Information Area, and a stand-
alone accent
is
displayed
at
the cursor location. To recover from this error,
press the RESET key and then rekey
both
the accent and a valid letter (or
space).
If
the Do Not Enter-What (
X?+
) message appears in the Operator Infor-
mation Area during a Dead Key operation, either
(1)
you
have taken an illegal
action or (2) the
host
system has interrupted
your
operation. Press the RESET
key, check the contents
of
your screen, and then rekey the accent and the
letter again.
By
now
you
should be quite familiar with
your
display station.
If
there
is
any area
that
you
are still not sure about,
turn
back and reread the
section
that
discusses it. Press
the
key or keys in question, and watch
the result.
If
you
still have questions, now
is
the time
to
get them answered.
Ask
the
appropriate person in
your
organization for an explanation.
Chapter 3. Keyboards J.45
To Next Page
Loading...
