Check Procedures 2-11
Table 2- 1 BIOS Error Codes, Messages, and Beeps List
BIOS Error Codes,
Messages, beeps
Action/FRU
NOTE:
To diagnose a problem, first find the BIOS error messages, codes,
or beeps in left column. If directed to a check procedure, replace the FRU
indicated in the check procedure. If no check procedure is indicated, the
first Action/FRU listed in right column is the most likely cause.
1780
IDE Primary Channel
Master Drive Error
1781
IDE Primary Channel
Slave Drive Error
A warning message to indicate there has
been change of IDE Primary (Secondary)
Channel Master (Slave) device.
Load default settings in Setup.
Check IDE drive jumper. See “3.5-In. Hard
Disk Drive Jumper Locations” on page 5-18
or "5.25-In Hard Disk Drive Jumper Location"
on page 5-23.
IDE drive power.
IDE drive cable/connection.
IDE drive.
1782
IDE Secondary Channel
Master Drive Error
1783
IDE Secondary Channel
Slave Drive Error
A warning message to indicate there has
been change of IDE Primary (Secondary)
Channel Master (Slave) device.
Load default settings in Setup.
Check IDE drive jumper. See “3.5-In. Hard
Disk Drive Jumper Locations” on page 5-18
or "5.25-In Hard Disk Drive Jumper Location"
on page 5-23.
IDE drive power.
IDE drive cable/connection.
IDE drive.
1800
PnP ISA Card(s) Disabled
Enter BIOS Setup and set the Reset
Resource Assignments parameter to Yes,
then reboot the system.
Remove all adapter cards that are NOT
factory-installed, then reboot the system
To Next Page
Loading...
Need help?
General
