AS/400e server 250 109
AS/400e server 250
#2818 PCI 155 Mbps Single-Mode Fiber OC3 ATM IOA
This feature allows the AS/400 system to be attached to an Asynchronous Transfer Mode
(ATM) network using the Single-Mode Fiber (SMF) 9 micron interface. This interface is
intended primarily for direct connection to service provider equipment but can be used for
local area switches. The #2818 is typically used where 155 Mbps speeds are required over
distances from 16 to 40 km. It uses one high-speed slot, but cannot be placed in the Base
System Unit. It can attach in slots E08 and E03 (where #2824 is a prerequisite) of the System
Expansion Unit (#7102). Technical specifications and industry standards supported are available
at the ATM Forum Web site:
http://www.atmforum.com The maximum is two.
#2866 PCI Integrated Netfinity Server
The Integrated Netfinity Server contains an Intel 333 MHz Pentium II Processor, four main
storage slots, and two LAN IOA slots. The adapter requires two reserved PCI card positions:
one for the processor card and the second for the bridge card to interface the processor card
to the AS/400 system. A maximum of two #2866 Integrated Netfinity Servers are supported:
one in the Base System Unit and one in the System Expansion Unit (#7102).
The Integrated Netfinity Server provides high-performance LAN serving to LAN-attached
PCs. OS/2 Warp Server for AS/400, Novell IntraNetWare, Lotus Domino, Flowmark, Firewall
for AS/400, or Microsoft Windows NT and Windows 2000 servers are supported on the
Integrated Netfinity Server.
The Integrated Netfinity Server comes with no base main memory and supports up to four of
the following features:
• #2861 32M IOP Memory Card
• #2862 128M IOP Memory Card
• #2867 256M IOP Memory Card
Each LAN slot can contain either a Token-Ring or an Ethernet IOA from the following list:
• #2723/#9723 PCI Ethernet IOA
• #2724/#9724 PCI 16/4 Mbps Token Ring IOA
• #2838/#9738 PCI 100/10 Mbps Ethernet IOA
There can only be one #2838/#9738 on each #2866 Integrated Netfinity Server. An external
cable is included to enable connectivity to Integrated Netfinity Server hardware (keyboard,
mouse), which also allows for optional use of parallel and serial ports.
If running Microsoft Windows NT on the Integrated Netfinity Server, these additional features
are required:
• #0325 IPCS Extension Cable for Windows NT (orderable)
• #1700 IPCS Keyboard/Mouse for Windows NT (default in some countries and orderable in
others)
To Next Page
Loading...
Need help?
General