IBM AS/400e

Towers 223
Towers
#5034 is mutually exclusive with #5033, #5035, and #5077.
#5035 Migration Tower I (15 Disk S20/620, 720 System)
The #5035 is a converted 620, S20, or 720 (with 15 possible internal CEC disk unit positions)
system unit/CEC tower and any existing #5064 or #9364 expansion unit, used for migration of
existing PCI/SPD cards, existing disk units and existing removable media devices, along with
any attached PCI/SPD towers. Additional “pre-V4R5” features may be ordered to use vacant
card/device slots in the converted CEC and expansion unit and in any attached PCI/SPD
tower. “V4R5 only” feature cards and internal devices are not allowed in the converted CEC
tower, the expansion unit, or any of the attached PCI/SPD towers.
This feature is for upgrade migrate purposes only and cannot be ordered separately.
The #5035 can only attach to Models 820 and 830.
There is a maximum of one #5035 on a Model 820 and 830.
Attaching additional PCI/SPD towers to the #5035 after migrating to the Model 820 is not
allowed.
Select two of the following (any combination) HSL cable features for this tower:
• #1460 - 3m Copper HSL cable
• #1461 - 6m Copper HSL cable
• #1462 - 15m Copper HSL cable
At least one of the HSL cables for the Model 820 must be either the #1460 or #1461. The
#1462 15m HSL cable can only be used on HSL port A1 of the Model 820 to directly connect
Migration Towers #5033, #5034, or #5035. The #1462 15m HSL cable can be used on all HSL
ports of the Models 830 and 840.
Select one of the following SPCN cables:
• #1463 - 2m SPCN cable
• #1464 - 6m SPCN cable
• #1465 - 15m SPCN cable
• #1466 - 30m SPCN cable
One JTAG-E cable (6m) is included with the #5035.
The existing system unit/CEC line cord should be used. Available line cord options are
identified in the
AS/400e System Builder, SG24-2155.
#5035 is mutually exclusive with #5033, #5034, and #5077.