Towers
216 AS/400e System Handbook
#5077 Migration Tower II
The #5077 is a feature I/O tower, which supports SPD I/O cards and attaches SPD Expansion
Towers and #5065/#5066 PCI Expansion Towers. The #5077 is supported on Models 830,
840, SB2, and SB3.
The #5077 may be ordered to support clustering on Models 830, 840, SB2, and SB3. In this
case the #5077 is shipped as a manufactured unit with a base CD-ROM and a base optical
link card (CCIN 2696). When ordered on a Model 830 or 840, the marketing configurator
defaults a #5057 16 Disk Unit Storage Expansion Unit on the order, which may be removed if
the customer does not want it. When attached to a Model SB2 or SB3, disk units may not be
installed in the #5077 (or #5057).
One or two #2695 Optical Bus Adapter features may be ordered for the #5077.
Select one of the following HSL cables if the #5077 has just the base optical link card
installed. Select two (any combination) of the following HSL cables if the #5077 has one or
two #2695 Optical Bus Adapters installed:
• #1460 - 3m Copper HSL cable
• #1461 - 6m Copper HSL cable
• #1462 - 15m Copper HSL cable
Select one of the following SPCN cables per tower:
• #1463 - 2m SPCN cable
• #1464 - 6m SPCN cable
• #1465 - 15m SPCN cable
• #1466 - 30m SPCN cable
One JTAG-C cable (6m) is included with the #5077.
If the #5077 is a manufactured unit, select one line cord with each #5077 Migration Tower II. If
the #5077 is converted from a #9251, a line cord is not required to be selected since the line
cord from the #9251 may be used. However, a line cord may be selected on a #9251 to #5077
conversion if the line cord type is to be changed.
Note: Some countries offer fewer choices of line cords, and some countries are shipped a
default line cord type.
#5077 is mutually exclusive with #5033, #5034, and #5035.
To Next Page
Loading...
