IBM Flex System x440 Compute Node User Manual

password
is the IMM2 account password (1 of 12 accounts). The default is
PASSW0RD (with a zero, not the letter O).
To update the DMI/SMBIOS data, complete the following steps:
1. In the ASU command-line interface, enter the following command:
asu set SYSTEM_PROD_DATA.SysInfoProdName xxxxyyy [--host ipaddress]
[--user userid][--password password]
where:
xxxx is the 4-digit machine type of the compute node.
yyy is the 3-digit model number of the compute node.
ipaddress
is the internal LAN/USB IP address of the IMM2. The default is
169.254.95.118.
userid is the IMM2 account name (1 of 12 accounts). The default is USERID.
password
is the IMM2 account password (1 of 12 accounts). The default is
PASSW0RD (with a zero, not the letter O).
2. Enter the following command:
asu set SYSTEM_PROD_DATA.SysInfoSerialNum zzzzzzz [--host ipaddress]
[--user userid][--password password]
where zzzzzzz is the 7-character serial number of the compute node.
3. Enter the following command:
asu set SYSTEM_PROD_DATA.SysEncloseAssetTag
aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa [--host ipaddress]
[--user userid][--password password]
where aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa is the 33-character asset tag number of
the compute node.
Remotely over a LAN
If you omit any optional parameter, the default value is used.
Procedure
To update the UUID, in the ASU command-line interface, enter the following
command:
asu set SYSTEM_PROD_DATA.SysInfoUUID uuid --host ipaddress
[--user userid][--password password]
where:
uuid is the user-assigned hexadecimal value, up to 16 bytes, that identifies the
compute node.
ipaddress
is the external LAN IP address of the IMM2.
userid is the IMM2 account name (1 of 12 accounts). The default is USERID.
34 IBM Flex System x440 Compute Node Types 7917 and 2584: Installation and Service Guide

IBM Flex System x440 Compute Node Specifications

General

Brand	IBM
Model	Flex System x440 Compute Node
Category	Server
Language	English