password
is the IMM2 account password (1 of 12 accounts). The default is
PASSW0RD (with a zero, not the letter O).
To update the DMI/SMBIOS data, complete the following steps:
1. In the ASU command-line interface, enter the following command:
asu set SYSTEM_PROD_DATA.SysInfoProdName xxxxyyy --host ipaddress
[--user userid][--password password]
where:
xxxx is the 4-digit machine type of the compute node.
yyy is the 3-digit model number of the compute node.
ipaddress
is the external LAN IP address of the IMM2.
userid is the IMM2 account name (1 of 12 accounts). The default is USERID.
password
is the IMM2 account password (1 or 12 accounts). The default is
PASSW0RD (with a zero, not the letter O).
2. Enter the following command:
asu set SYSTEM_PROD_DATA.SysInfoSerialNum zzzzzzz --host ipaddress
[--user userid][--password password]
where zzzzzzz is the 7-character serial number of the compute node.
3. Enter the following command:
asu set SYSTEM_PROD_DATA.SysEncloseAssetTag
aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa --host ipaddress
[--user userid][--password password]
where aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa is the 33-character asset tag number of
the compute node.
Configuring a RAID array
Use this information to configure a RAID array.
About this task
Configuring a RAID array applies only to a compute node in which two or more
hard disk drives are installed.
Note: When you configure a RAID array, the hard disk drives must use the same
type of interface. For example, a RAID array can be configured with two SAS hard
disk drives or two SATA hard disk drives.
You can use two hard disk drives in the compute node to implement and manage
RAID level-0 (striping) or RAID level-1 (mirror) arrays in operating systems that
are listed on the ServerProven list at http://www.ibm.com/systems/info/
x86servers/serverproven/compat/us/. For the compute node, you must configure
the RAID by using the LSI Configuration Utility program.
Chapter 2. Configuring 35
To Next Page
Loading...
Need help?
General