Figure 75. Disconnecting the signal cable and power cable
Replacing the drive backplane signal cable in the 5105-22E, 9008-22L, 9009-22A,
9009-22G, or 9223-22H system
To replace a drive backplane signal cable in the system, complete the steps in this procedure.
Procedure
1. Ensure that you have the electrostatic discharge (ESD) wrist strap on and that the ESD clip is plugged
into a ground jack or connected to an unpainted metal surface. If not, do so now.
2. Using your labels, reconnect the signal cable (A) to the drive backplane as shown in Figure 76 on page
84.
Push the connector in until the latch clicks.
Drive backplane cables in the 5105-22E, 9008-22L, 9009-22A, 9009-22G, or 9223-22H
83
To Next Page
Loading...
