c. Press the interposer card down onto the interposer card connector on the
RAID adapter until it is firmly seated.
d. From underneath the RAID adapter, insert the screw that you took from
the bag and tighten the screw to secure the interposer card to the RAID
adapter.
6. Connect one end of the remote battery cable to the interposer card.
Attention: To avoid damage to the hardware, make sure that the black dot
on the remote battery cable connector faces away from the interposer card on
the adapter. Do not force the remote battery cable into the connector.
7. Install the RAID adapter on the riser-card and install the riser-card assembly
in the server (see “Installing a PCI riser-card assembly” on page 69).
8. Connect the other end of the remote battery cable to the remote battery cable
connector on the battery carrier.
Attention: To avoid damage to the hardware, make sure that the black dot
on the remote battery cable connector faces away from the interposer card on
the adapter. Do not force the remote battery cable into the connector.
9. Route the remote battery cable in server and through the slots on the RAID
battery tray as shown in the following illustrations (depending on the PCI slot
in which the RAID adapter is installed.
Attention: Make sure that the cable is not pinched and does not cover any
connectors or obstruct any components on the system board.
98 System x3690 X5 Types 7147, 7148, 7149, and 7192: Installation and User's Guide
To Next Page
Loading...
