8. Connect the other end of the power cord to a properly grounded electrical
outlet.
9. Make sure that the ac power LED and the dc power LED on the power
supply are lit, indicating that the power supply is operating correctly. The two
green LEDs are to the right of the power-cord connector.
10. Restart the host server. Confirm that it starts correctly and recognizes the
newly installed devices, and make sure that no error LEDs are lit.
11. Complete the additional steps in “Instructions for IBM Business Partners” on
page 34.
Completing the MAX5 installation
To complete the MAX5 expansion module installation, complete the following
steps:
1. Reinstall the system-board tray (see “Replacing the MAX5 system-board tray.”).
2. Reinstall the MAX5 bezel (see “Replacing the MAX5 bezel” on page 128).
3. Reconnect the cables and power cords (see “Connecting the MAX5 cables” on
page 128).
4. Turn on the peripheral devices and the host server.
5. Confirm that the host server start correctly and recognizes the newly installed
devices, and make sure that no error LEDs are lit.
6. Slide the MAX5 and the server back into the rack, if necessary.
Replacing the MAX5 system-board tray
To replace the system-board tray, complete the following step:
1. Read the safety information that begins on page “Safety” on page v and
“Installation guidelines” on page 44.
2. Grasp the system-board tray on both sides (near the stop-tabs) and align the
system-board tray with the chassis.
Stop-tab
Release latch
Release latch
Stop-tab
Handle
Handle
3. Slide the system-board tray forward until the tabs at the bottom of the handles
touch the chassis; then, close the handles and press firmly on the release latches
to snap them into the locked position.
4. Replace the bezel (see “Replacing the MAX5 bezel” on page 128).
Chapter 2. Installing optional devices 127
To Next Page
Loading...
