2. Squeeze the tabs on the ends of the fan cage assembly release latches and hold
them while rotating the release latches down until the release latches are in the
locked position.
Note: It is easier to rotate the release latches to the locked position in the
server when you squeeze the tabs and hold them.
Replacing the server top cover
To replace the server cover, complete the following steps:
1. Make sure that all cables, adapters, and other components are installed and
seated correctly and that you have not left loose tools or parts inside the server.
Also, make sure that all internal cables are correctly routed.
2. Align the cover over the server (toward the rear of the server) until the cover
edges slip into position over the chassis.
Important: Before sliding the cover forward, make sure that all the tabs on the
cover engage the chassis correctly. If all the tabs do not engage the chassis
correctly, it will be hard to remove the cover later.
Top cover
Cover release
latch
3. Slightly slide the cover toward the front of the server until the inset tabs start
to engage on the server; then, press down on the cover release latch until it
clicks into place.
Chapter 2. Installing optional devices 115
To Next Page
Loading...
