12. Slide the system-board tray forward until the tabs on the bottom of the
handles touch the chassis; then, close the handles and press firmly on the
release latches to snap them into the locked position.
If you have other devices to install or remove, do so now. Otherwise, go to
“Completing the MAX5 installation” on page 127.
Installing a MAX5 hot-swap power supply
The following notes describe the type of power supply that the MAX5 expansion
module supports and other information that you must consider when you install a
power supply:
v Confirm that the MAX5 supports the power supply that you are installing, see
http://www.ibm.com/systems/info/x86servers/serverproven/compat/us/.
v The IBM MAX5 for System x memory expansion module comes with one
675-watt hot-swap 12-volt output power supply. The input voltage is 110 V ac or
220 V ac auto-sensing. Two power supplies must be installed for redundancy
support.
Note: You cannot mix 110 V ac and 220 V ac power supplies in the MAX5, it is
not supported.
v These power supplies are designed for parallel operation. In the event of a
power-supply failure, the redundant power supply continues to power the
system. The server supports a maximum of two power supplies.
Statement 5
CAUTION:
The power control button on the device and the power switch on the power
supply do not turn off the electrical current supplied to the device. The device
also might have more than one power cord. To remove all electrical current from
the device, ensure that all power cords are disconnected from the power source.
1
2
Statement 8
Chapter 2. Installing optional devices 125
To Next Page
Loading...
