Replacing the microprocessor air baffle
To install the microprocessor air baffle, complete the following steps:
1. Read the safety information that begins on page “Safety” on page v and
“Installation guidelines” on page 44.
2. Align the tabs on the air baffle with the slots on the power supply cage and the
chassis wall; then, slide the air baffle down until it is seated firmly with the
baffle tabs in the holes on the power supply cage and chassis wall.
Microprocessor
air baffle
Ta b
Ta b
Alignment sots
Replacing the memory tray
To replace the memory tray, complete the following steps:
1. Read the safety information that begins on page “Safety” on page v and
“Installation guidelines” on page 44.
2. Align the tabs on the sides of the memory tray with the slots on the power
supply cage and the chassis wall and lower the memory tray into the server.
Chapter 2. Installing optional devices 113
To Next Page
Loading...
