11. Take the battery retention clip and place it underneath the other tab while
pressing the release tab toward the side of the server; then, press it down until
it snaps in place to hold the battery carrier firmly in place.
If you have other devices to install or remove, do so now. Otherwise, go to
“Completing the installation” on page 112.
Installing the optional simple-swap SATA drive and backplate
assembly
To install the optional simple-swap SATA drive and backplate assembly, complete
the following steps:
Note:
1. If you install the simple-swap SATA drive and backplate assembly in the server,
the backplate must be installed in the backplane slot closest to the information
panel and the SATA drive must be installed in the drive-bay closest to the
information panel.
2. When you install this option in the server, you will no longer be able to install
the optional CD-DVD ROM drive in the server because you will need to
connect the cable for this simple-swap SATA drive option to the
CD/DVD-ROM drive connector on the system board. That is, you cannot have
the simple-swap SATA drive and backplate assembly and the CD/DVD-ROM
drive installed in the server at the same time. They both connect to the same
connector on the system board.
Note:
1. Read the safety information that begins on page “Safety” on page v and
“Installation guidelines” on page 44.
2. Turn off the server (see “Turning off the server” on page 24) and all attached
peripheral devices. Disconnect all power cords; then, disconnect all external
cables from the server.
3. Remove the top cover (see “Removing the server top cover” on page 46).
4. Remove the fan cage assembly (see “Removing the fan cage assembly” on
page 50).
5. If a backplane filler panel is installed in the slot where you are installing the
backplate assembly, remove the backplane filler panel.
6. Align the tabs on the bottom of the drive backplate with the backplate slots
on the bottom of the backplane cage.
7. Insert the drive backplate tabs into the slots on the bottom of the backplate
cage and lift up the retention latch on top of the backplane cage; then, rotate
the drive backplate assembly forward until the backplate snaps into place into
the retention latch on the drive cage.
Chapter 2. Installing optional devices 101
To Next Page
Loading...
