IBM System x3690 X5 - Replacing the MAX5 Bezel; Connecting the MAX5 Cables

Replacing the MAX5 bezel
To replace the MAX5 bezel, complete the following steps:
1. Read the safety information that begins on page “Safety” on page v and
“Installation guidelines” on page 44.
2. Align the bezel alignment tabs with the chassis and press the bezel onto the
chassis until it snaps into place.
Bezel
Alignment
tab
Alignment
tab
Release
tab
Release
tab
Connecting the MAX5 cables
To cable the MAX5 to the host server, see the QPI cable option documentation and
the EXA cable option documentation. Be sure to turn off the host server before you
connect any cables to or disconnect any cables from the MAX5 memory expansion
module.
The following illustration shows the locations of the connectors on the rear of the
MAX5.
Power-on
LED
Locate
LED
System
error
LED
AC LED (green)
DC LED (green)
Power supply
fault (error) LED
QPI
port 1
Power
connectors
EXA port 1
LEDlink
EXA port 2
LEDlink
EXA port 3
LEDlink
EXA
port 1
EXA
port 2
EXA
port 3
QPI
port 2
QPI
port 3
QPI
port 4
128 System x3690 X5 Types 7147, 7148, 7149, and 7192: Installation and User's Guide