Power supply
connector 3
Power interposer
card
Power header
connectors
Power supply
connector 4
Power cable
connector
6. Install the power supplies that came with the power interposer card option (see
“Installing a hot-swap power supply” on page 92).
If you have other devices to install or remove, do so now. Otherwise, go to
“Completing the installation” on page 112.
Installing a USB embedded hypervisor flash device
To install a hypervisor flash device, complete the following steps:
1. Read the safety information that begins on page “Safety” on page v and
“Installation guidelines” on page 44.
2. Turn off the server (see “Turning off the server” on page 24) and all attached
peripheral devices. Disconnect all power cords; then, disconnect all external
cables from the server.
3. Remove the top cover (see “Removing the server top cover” on page 46).
4. Locate the embedded hypervisor USB flash device connector on the one-slot
side of the three-slot PCI riser card as shown in the following illustration:
Chapter 2. Installing optional devices 95
To Next Page
Loading...
